Wings 3D Development Forum

Hey

I made a model and a texture for a space station, but I can't unwrap the model properly. I tried to unwrap it like a sphere and cylinder, but it doesn't look like I want it:



I would describe the shape of the model as a "helmet"(it's empty inside), is there a good way to unwrap it right?

, Westbeam

By considering the texture you are using (with those lines) I believe the better option would be to use the Projection Camera option:

In this case I just marked for cut the helmet boundaries (two edge loops separating the in/out side); changed the view mode to Orthogonal and put the view along the Y axis. After created the UVMap it was needed a little of tweak in the opened mesh.

Thank your very much micheus

That was everything I needed to finish the station. Watch it here: http://www.wings3d.com/forum/showthread.php?tid=1082