02-04-2013, 07:26 PM
Maybe the more adequated would be to request some Display Info (top left work area) improvements, but, anyway...
When i select two or more contiguous edges, i just have at Display Info the number of edges (or their id)...
If i need to measure the total length of them, i have to call Edge|Set Constraint|Total Length|Normal and then i have to go to Edit|Preferences|Constraints to verify the result at "Distance Constraints" session...
I think this kind of measurement could be smarter or, at least, the results could be visible out Preferences window, or, the ideal imo, Display Info could show it.
Thanks.
When i select two or more contiguous edges, i just have at Display Info the number of edges (or their id)...
If i need to measure the total length of them, i have to call Edge|Set Constraint|Total Length|Normal and then i have to go to Edit|Preferences|Constraints to verify the result at "Distance Constraints" session...
I think this kind of measurement could be smarter or, at least, the results could be visible out Preferences window, or, the ideal imo, Display Info could show it.
Thanks.