Wings 3D Development Forum

Fix updated: wings_face_cmd.beam
I hope we have covered all possibilities.

I'll test tonight, Micheus.
-------------

When possible, take a look at the following thread, about the impossibility to shortcut the Sculpt commands. It is crucial to solve that: otherway, it will be a waste of time (very burocratic) to use those so useful commands.

http://www.wings3d.com/forum/showthread.php?tid=2233

(11-16-2016 06:36 PM)Fonte Boa Wrote: [ -> ]When possible, take a look at the following thread, about the impossibility to shortcut the Sculpt commands. It is crucial to solve that: otherway, it will be a waste of time (very burocratic) to use those so useful commands.

http://www.wings3d.com/forum/showthread.php?tid=2233

I'm on it.

Thank you so much, Micheus.

It seems it is ok in the anterior situations, but...

Create a cube, select an edge ring, connect, loop cut, move one half away the other.
Then select two faces facing each order and try to use RMB Bridge: user cant complete this operation.

I've recorded a video.

(11-16-2016 09:21 PM)Fonte Boa Wrote: [ -> ]Create a cube, select an edge ring, connect, loop cut, move one half away the other.
Then select two faces facing each order and try to use RMB Bridge: user cant complete this operation.

That is a very interest finding. If used two cubes (using copy) it works. The problem happens only they were created by a cut.

RMB Bridge will work in this case if you Combine both half cubes and then Separate them again.

Fix updated: wings_face_cmd.beam

I testes with all the options with problem as pointed before and it still seems to be working.
Please check it.

I'll test it (and Tools|Smooth shortcut) tonight.

Micheus, i couldnt find more problems using Bridge commands.
It is ok to me. Thanks for your great work.