(12-09-2012 02:34 AM)micheus Wrote: [ -> ]With the edges selected, I invoce the command and I use:
- vertex 1 as reference point, then RMB (continue);
- vertex 2 as target point, then RMB (continue).
Micheus, you have to connect the two vertices before Snap them; otherwise there will be two coincident vertices impossible to be connected.
(12-09-2012 12:18 PM)Fonte Boa Wrote: [ -> ]Micheus, you have to connect the two vertices before Snap them; otherwise there will be two coincident vertices impossible to be connected.
I just forgot make mention to
Cleanup command - as you have already used it too.
(12-09-2012 09:48 PM)micheus Wrote: [ -> ] (12-09-2012 12:18 PM)Fonte Boa Wrote: [ -> ]Micheus, you have to connect the two vertices before Snap them; otherwise there will be two coincident vertices impossible to be connected.
I just forgot make mention to Cleanup command - as you have already used it too.
Cleanup command wont produce any effect if before you dont connect the (1)/(2) vertices indicated at your pic (Cleanup works elimitating coincident vertices just IF they are connected each other):
"Ugly" faces are really a "hard" thing for newbies understand imo. Some basic situations i think about are in the following video.
A useful workflow (it doesnt solve every situations) is by performing the command Face|Tesselate|Quadrangulate.
Scale edge (and vert too) along an Axis to a Point (mmb Scale Axis) is way it is shown in video to solve more "complex" situations.
