+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Interface & Usage (https://www.wings3d.com/forum/forumdisplay.php?fid=3)
+--- Thread: How to use mirror? (/showthread.php?tid=1654)
How to use mirror? - cyseal - 04-04-2016
How to use mirror so that you model only one side of the mesh and then just mirror it on other?
For example, in modeling this dragon I would like to model only one side and then mirror it to other.
RE: How to use mirror? - ggaliens - 04-04-2016
Personal opinion ... don't use virtual mirror. Just use loop-cut and mirror only as often as you really need it.
RE: How to use mirror? - cyseal - 04-04-2016
(04-04-2016, 11:52 AM)ggaliens Wrote: Personal opinion ... don't use virtual mirror. Just use loop-cut and mirror only as often as you really need it.
I don't understand.
RE: How to use mirror? - micheus - 04-04-2016
(04-04-2016, 09:40 AM)cyseal Wrote: How to use mirror so that you model only one side of the mesh and then just mirror it on other?Usually you do it this way: https://youtu.be/Bl4ngBPIRVI?t=1m55s
RE: How to use mirror? - ggaliens - 04-04-2016
I would to what Micheus did ... except I would pick face/mirror rather than virtual mirror.
I don't like the constant updates while I'm working. I only need it every so often.
RE: How to use mirror? - cyseal - 04-04-2016
Thanks.
RE: How to use mirror? - Mishou - 04-04-2016
I use virtual mirror while modelling in order to be able to get the best view angle, however, in the end i remove the virtual one and i pick a face and mirror it in the end.