+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Interface & Usage (https://www.wings3d.com/forum/forumdisplay.php?fid=3)
+--- Thread: Drawing Integrated Circuits (/showthread.php?tid=1972)
Drawing Integrated Circuits - Gandalf_Sr - 05-16-2016
I want to draw ICs and am struggling to add the dimple that usually marks pin 1 like in this picture
Can someone please outline the steps to do this?
I have done the legs too but I drew 1 leg and then used Duplicate many times over, is there an array function in Wings?
Thanks in advance.
RE: Drawing Integrated Circuits - micheus - 05-16-2016
Except if you need to use a small amount of faces the easier way to do this kind of object (as I see) is to working with a grid.
In that situation you have the option to extract a side face to create the face and then use Put On [RMB] to automatically duplicate it over the all other lateral faces.
For the dimple, the use of many faces (edges) will help you to create it easily too by using circularize.
If nobody else give you anything else soon I'm going to prepare a small tutorial about how to run these steps.
RE: Drawing Integrated Circuits - micheus - 05-17-2016
Gandalf_Sr, I ended up producing a step by step and added it to the How To session. Please check the thread Integrated Circuits
RE: Drawing Integrated Circuits - Gandalf_Sr - 05-17-2016
Micheus, Great job thank you so much.
RE: Drawing Integrated Circuits - imagine - 08-01-2020
very nice video! thanks a lot for all your work and effort