Wings 3D Development Forum
[not bug] Bug with rotation function. - Printable Version

+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Bug Reports (https://www.wings3d.com/forum/forumdisplay.php?fid=12)
+--- Thread: [not bug] Bug with rotation function. (/showthread.php?tid=3108)



[not bug] Bug with rotation function. - ptoing - 05-02-2023

What basically happens is that when rotating an object with standard rotation around the XYZ axes, instead of using the bounding box of the object there is some weird offset depending on vertex distribution.

An easy way to test this is to make a cube with an offcenter inset on the top, like in my attachment, and now rotate it on Y, It will rotate differently depending where the inset is. Same goes for X and Z actually, just tested that quickly while typing this.

I find this behaviour VERY unintuitive and would think that rotation around center of the bounding box would make the most sense.

(version was 2.2.9)


RE: Bug with rotation function. - micheus - 05-02-2023

Hi ptoing

This is not a bug, it's a feature. It uses the selection centroyd.

If you want it to be using the center of the bounding box then you need to use the RMB option and select the entire object in order to get the bounding box's center point. Smile


RE: [not bug] Bug with rotation function. - ptoing - 05-02-2023

Hah, kinda weird as the default option maybe, but I learned something today Biggrin