+- Wings 3D Development Forum (http://www.wings3d.com/forum)
+-- Forum: Wings 3D (/forumdisplay.php?fid=1)
+--- Forum: Interface & Usage (/forumdisplay.php?fid=3)
+--- Thread: FACE REGION to (boundary) EDGE LOOP ?? (/showthread.php?tid=616)
FACE REGION to (boundary) EDGE LOOP ?? - Arg Arg - 03-17-2014 04:18 PM
is there a way in wings to convert a selected face region
into (boundary) edge-loop (of the face region) ??
in other words:
the reversed result of the already
included command "EDGE LOOP TO REGION"
RE: FACE REGION to (boundary) EDGE LOOP ?? - micheus - 03-17-2014 04:35 PM
(03-17-2014 04:18 PM)Arg Arg Wrote: is there a way in wings to convert a selected face region into (boundary) edge-loop (of the face region) ??See menu Select->Edge Loop [L]
Quote:the reversed result of the already included command "EDGE LOOP TO REGION"Select->Edge Loop to region [SHIFT+L] - that is the opposite of the previous one.
RE: FACE REGION to (boundary) EDGE LOOP ?? - Arg Arg - 03-17-2014 04:44 PM
thank you micheus!
this command is a little bit hidden from the eyes of the user
RE: FACE REGION to (boundary) EDGE LOOP ?? - digitaldavinci - 03-21-2019 08:26 PM
Put in body drop down menus?
RE: FACE REGION to (boundary) EDGE LOOP ?? - micheus - 03-21-2019 09:13 PM
Sorry, but I didn't understand your doubt.
The command - subject of this thread - is under main menu Select option.