+- Wings 3D Development Forum (http://www.wings3d.com/forum)
+-- Forum: Wings 3D (/forumdisplay.php?fid=1)
+--- Forum: Interface & Usage (/forumdisplay.php?fid=3)
+--- Thread: Round bevel (/showthread.php?tid=691)
Pages: 1 2
Round bevel - Asticles - 04-22-2014 10:04 AM
Hi to all,
I'm doing round bevels selecting the loops of a chamfer and chamfering again and again... xD
Is there any better procedure to make the chamfers more regular?
I know is not fair to compare but I'm used to blender's bevel, where you can set the radius.
Thanks!
RE: Round bevel - Nova - 04-22-2014 11:50 AM
It's a bit tedius, but if you've beveled a few times, select the "loop" of the bevel in edge mode and use circularize. Repeat with each loop, to make it regular.
RE: Round bevel - Fonte Boa - 04-22-2014 12:06 PM
After 1st Bevel, i select the resultant Edge Ring, Cut them in 4 parts (for example), Connect them (rmb option), expand the selection hitting E(dge), Deselect Previous (under Select top menu) and finish using Circularize.
edit: it seems me and Nova were typing together...
RE: Round bevel - Nova - 04-22-2014 01:41 PM
I forgot that the correct term was edge ring though
Thanks for clearing that up.
RE: Round bevel - Asticles - 04-22-2014 01:55 PM
Thanks! I have tested it and it worked, but when the angle turns I'm getting weird results. I will do more tests.
Thank you all.
RE: Round bevel - Fonte Boa - 04-22-2014 03:44 PM
I've recorded my steps: sorry for be soooo slowly. I didnt use any shortcuts so that the video could be more didatic.
RE: Round bevel - Asticles - 04-22-2014 03:52 PM
Great video, thanks!
RE: Round bevel - Arg Arg - 04-22-2014 06:56 PM
http://i59.tinypic.com/b6oejd.jpg
http://i58.tinypic.com/2cqbpso.jpg
RE: Round bevel - micheus - 04-22-2014 08:41 PM
I would try an other option, but I'm not able to sit in front a PC for a couple of weeks. I'm using my wings tablet.
Arg Arg , that is a interesting approach for your tutos - how to achieve actions we have in other applications but not in wings (at least not explicitly).
RE: Round bevel - Asticles - 04-23-2014 11:27 AM
I've tried Flowconnect and its great! Only I have to remember to check possible offsets.
Also, is there any wishlist for new versions?
michelus, wings tablet? o_O