+- Wings 3D Development Forum (http://www.wings3d.com/forum)
+-- Forum: Wings 3D (/forumdisplay.php?fid=1)
+--- Forum: Interface & Usage (/forumdisplay.php?fid=3)
+--- Thread: Cut a half-hole in a cylinder (/showthread.php?tid=719)
Cut a half-hole in a cylinder - martinj - 05-15-2014 06:17 AM
Hi all!
I am new to wings3d.
I have been to do a half-hole on the side of a cylinder but I cannot get it right. Please see attached image, I want to "drill" a hole with one of the cylinders into the other one.
Any suggestions?
Thanks!
RE: Cut a half-hole in a cylinder - Justanother1 - 05-15-2014 08:24 PM
Easiest way would require the Manofoldlab version of the Program .. (google it) .. with the extra plugins. Boolean is what your looking for in Object Mode - Lots more ...... different versions have different options and clicks so read the helper instructions .....
RE: Cut a half-hole in a cylinder - martinj - 05-15-2014 09:39 PM
(05-15-2014 08:24 PM)Justanother1 Wrote: Easiest way would require the Manofoldlab version of the Program .. (google it) .. with the extra plugins. Boolean is what your looking for in Object Mode - Lots more ...... different versions have different options and clicks so read the helper instructions .....
Nice! Just what I was looking for.
Cheers