|
[fixed] Sculpt + Wire mode
|
|
10-03-2018, 04:31 PM
(This post was last modified: 11-27-2018 02:34 PM by micheus.)
Post: #1
|
|||
|
|||
 [fixed] Sculpt + Wire mode
Hi there,
W3D 2.1.7 Steps: 1. add any object 2. change mode to wire (W) 3. go to Sculpt 4. Start sculpting (just few clicks is enough) 5. turn off wire mode (W) Can't get original shading - object is permanently in wire mode. If you start sculpting in normal mode then it's OK. BR, Hank My gallery: marcone.pl |
|||
|
11-27-2018, 02:34 PM
Post: #2
|
||||
|
||||
|
RE: Sculpt + Wire mode
That was fixed and will be available in the next release.
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)