Wings 3D Development Forum
/
Wings 3D
/
Design & Development 
/
Routine for union of St0#st.sel with St1#st.sel ?
/
Routine for union of St0#st.sel with St1#st.sel ?
|
Routine for union of St0#st.sel with St1#st.sel ?
|
|
01-13-2015, 08:46 PM
Post: #1
|
|||
|
|||
|
Routine for union of St0#st.sel with St1#st.sel ?
Routine for union of St0#st.sel with St1#st.sel ... where ?
I think a few of these exist in various modules. But I'd suspect perhaps w/o proper export ... so as to be available to other programmer and plugin modules. One I found was wings_sel_cmd:union ... BUT it needs export. Just wondering if I missed something. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Routine for union of St0#st.sel with St1#st.sel ? - ggaliens - 01-13-2015 08:46 PM
|
User(s) browsing this thread: 1 Guest(s)