|
Cutting out a hole
|
|
01-20-2015, 11:23 AM
(This post was last modified: 01-20-2015 11:23 AM by micheus.)
Post: #7
|
||||
|
||||
RE: Cutting out a hole
(01-20-2015 08:28 AM)matt Wrote: If the pieces of the badge are merged, will I be able to texture the two wings and the central piece with induvidual colors, or should the left and right wing be separated from the central piece?It is up to you decide about that.  You can use both approaches. This is the 1st of two videos showing how to UVMap separated objects and then merging them at the end.
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Cutting out a hole - matt - 01-19-2015, 09:30 AM
RE: Cutting out a hole - Hank - 01-19-2015, 01:00 PM
RE: Cutting out a hole - Radi - 01-19-2015, 04:11 PM
RE: Cutting out a hole - matt - 01-19-2015, 05:35 PM
RE: Cutting out a hole - micheus - 01-19-2015, 06:35 PM
RE: Cutting out a hole - matt - 01-20-2015, 08:28 AM
RE: Cutting out a hole - micheus - 01-20-2015 11:23 AM
RE: Cutting out a hole - matt - 01-21-2015, 08:28 AM
|
User(s) browsing this thread: 1 Guest(s)