Wings 3D Development Forum
/
Wings 3D
/
Interface & Usage 
/
How to select edges by nearly same length?
/
How to select edges by nearly same length?
|
How to select edges by nearly same length?
|
|
12-12-2012, 06:19 PM
(This post was last modified: 12-12-2012 06:22 PM by Fonte Boa.)
Post: #2
|
|||
|
|||
|
RE: How to select edges by nearly same length?
Select|By|Short Edges
Right click on it (or on the little box side command name) and set the tolerance. Wings will select all edges which length is equal or inferior to that value. It is limitated, but it is the only way i remembered. __________________________________ http://www.youtube.com/wings3dchannel http://www.facebook.com/wings3dchannel |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How to select edges by nearly same length? - ggaliens - 12-12-2012, 06:11 PM
RE: How to select edges by nearly same length? - Fonte Boa - 12-12-2012 06:19 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 06:22 PM
RE: How to select edges by nearly same length? - Fonte Boa - 12-12-2012, 06:24 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 06:28 PM
RE: How to select edges by nearly same length? - Fonte Boa - 12-12-2012, 06:32 PM
RE: How to select edges by nearly same length? - optigon - 12-12-2012, 06:33 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 06:37 PM
RE: How to select edges by nearly same length? - optigon - 12-12-2012, 06:43 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 07:01 PM
RE: How to select edges by nearly same length? - optigon - 12-12-2012, 07:07 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 07:31 PM
|
User(s) browsing this thread: 1 Guest(s)