Wings 3D Development Forum
/
Wings 3D
/
Interface & Usage 
/
How to select edges by nearly same length?
/
How to select edges by nearly same length?
|
How to select edges by nearly same length?
|
|
12-12-2012, 06:43 PM
Post: #9
|
|||
|
|||
|
RE: How to select edges by nearly same length?
Sure.
One thing I notice is that the matching is currently set to Less Than the input value. Could you change this to Equal to or Less Than? Makes more sense that way 
|
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How to select edges by nearly same length? - ggaliens - 12-12-2012, 06:11 PM
RE: How to select edges by nearly same length? - Fonte Boa - 12-12-2012, 06:19 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 06:22 PM
RE: How to select edges by nearly same length? - Fonte Boa - 12-12-2012, 06:24 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 06:28 PM
RE: How to select edges by nearly same length? - Fonte Boa - 12-12-2012, 06:32 PM
RE: How to select edges by nearly same length? - optigon - 12-12-2012, 06:33 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 06:37 PM
RE: How to select edges by nearly same length? - optigon - 12-12-2012 06:43 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 07:01 PM
RE: How to select edges by nearly same length? - optigon - 12-12-2012, 07:07 PM
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012, 07:31 PM
|
User(s) browsing this thread: 1 Guest(s)