Wings 3D Development Forum / Wings 3D / Interface & Usage v / How to select edges by nearly same length?

New Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
Share Thread:
Reddit Facebook Twitter
How to select edges by nearly same length?
12-12-2012, 07:31 PM (This post was last modified: 12-12-2012 07:58 PM by ggaliens.)
Post: #12
ggaliens Offline
Erlang Hacker
 		Posts: 954
Joined: Nov 2012
RE: How to select edges by nearly same length?
Shoot. That makes sense. Hold on and I'll try to integrate and then do pull request.
Sorry for confusion. I need to reintegrate all my stuff with a local dgud master because I can (on my machine).

Only my local copies of branches for very recent pull-requests are up-to-date. I need to get universally uptodate including my ManifoldLab tree which is going to go back to plain-old-plugin distribution (TARBALL). I need to get that forked-distro monkey off my back ASAP.
OK ... formal branch with PULL-REQUEST done.

Shoot. Yep ... I messed up and will need to self close it. I'm a dummy. I'm still out of SYNC. No preview !
Find Reddit Facebook Twitter
Reply
New Reply


Messages In This Thread
RE: How to select edges by nearly same length? - ggaliens - 12-12-2012 07:31 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Wings 3D Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication