Difficulty with edge highlighting and selections.

[Anthony]

ggaliens as my father would say as the smoke was pouring from the exhaust pipe "there's nothing wrong with it" your prayers and plugins are most welcome though,thanks.
And yes micheus the edge sizes that is it.

Ok
Some results

Fiddled with edge offsets for some time and found no difference merely
chancing with different settings I don't know how it works or what it is
supposed to do but could see a change in the appearance of my sphere
and wire when taken up to 100

For me with default wings settings

In object selection mode wires look good, fine but good.
In face selection mode wires appear a little heavier.
In vertex selection mode wires remain like face selection mode,vertices
of course showing up well,not too much.
In edge selection mode width of wires become even thicker, I would
guess 2.0 of whatever 2.0 is which is the default setting we have in
all edge display width preferences.

All the above without selecting anything, just switching between modes.

So why do the wires appear thicker in edge selection mode everything is
set at 2.0 ? with nothing selected. I believe maybe this has something
to do with what I see or don't see to be precise.

I changed the edge display unselected width to 1.0 and selected width
to 1.5 with success and now am able to see my highlights and
selections although not as bright as I would like, my eyes ain't that
good, I have two screens here one on the notebook and my main monitor really works well for me, and ain't never had a new car but driven plenty.

Thanks again both of you.