Wings 3D Development Forum / Wings 3D / Interface & Usage v / Bend: Quick Start tutorial

New Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
Share Thread:
Reddit Facebook Twitter
Bend: Quick Start tutorial
12-21-2012, 05:51 PM
Post: #13
oort Offline
3D Obsessed
 		Posts: 1,158
Joined: Nov 2012
RE: Bend: Quick Start tutorial
Fonte Boa,
That is a nice tip about edge loops. I noticed that it only works in the new 1.5... snapshot version.

oort
Website Find Reddit Facebook Twitter
Reply
New Reply


Messages In This Thread
Bend: Quick Start tutorial - Fonte Boa - 12-18-2012, 11:51 PM
RE: Bend: Quick Start tutorial - Fonte Boa - 12-19-2012, 01:09 AM
RE: Bend: Quick Start tutorial - oort - 12-19-2012, 03:35 PM
The joys of Fonte Boa - maker - 12-20-2012, 08:36 AM
RE: Bend: Quick Start tutorial - Fonte Boa - 12-20-2012, 08:40 PM
RE: Bend: Quick Start tutorial - oort - 12-20-2012, 09:31 PM
RE: Bend: Quick Start tutorial - Fonte Boa - 12-20-2012, 11:20 PM
RE: Bend: Quick Start tutorial - Fonte Boa - 12-20-2012, 11:22 PM
RE: Bend: Quick Start tutorial - maker - 12-22-2012, 03:10 AM
RE: Bend: Quick Start tutorial - Fonte Boa - 12-21-2012, 12:40 PM
RE: Bend: Quick Start tutorial - oort - 12-21-2012 05:51 PM
RE: Bend: Quick Start tutorial - Fonte Boa - 12-21-2012, 06:37 PM
RE: Bend: Quick Start tutorial - oort - 12-21-2012, 09:19 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Wings 3D Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication