Threaded Mode | Linear Mode

oort · (This post was last modified: 10-04-2015 05:09 AM by oort.)

Emit,
It has been years since I have tried making sculpted prims. They have to be made from a mesh that has a certain number of faces. I think they have to have uv mapping as well. There used to be templates out on the web somewhere. Here is a page that gives some information, but the links to the templates no longer work...Secondlife Wiki Wings 3D Exporter

The following info is at the bottom of the page:

"Beware, though, that Wings will easily shift from the (commonly used) Export to the (rarely used) Export Selected if your mouse passes over the Export Selected line as you move to the Export sub-menu. If exporting gives you an "Unsupported mesh size" error when you know your mesh is OK, it's probably because you executed Export Selected by mistake."

I think that if your mesh has too many or not enough faces you will get the same error message.

Creating sculpted prims takes lots of patience. I had the patience to create one or two and that was about it... Sad

I just checked and I still have old sculpted prim templates on my computer. Let me know if you cannot find the templates. I can put them on my website...

oort