|
Tutorial on hardsurface with creasetool
|
|
12-20-2015, 03:31 PM
(This post was last modified: 12-20-2015 03:34 PM by micheus.)
Post: #2
|
||||
|
||||
|
RE: Tutorial on hardsurface with creasetool
Good tip!
People use to forget about it and end up creating new edge loops with connect and slide them. You also can speed up your selections in that sample by selecting only the first edge (left) and the last one (right) and than use select edge ring [G] As it seems you did after select half of them. 
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tutorial on hardsurface with creasetool - studiof - 12-20-2015, 01:45 PM
RE: Tutorial on hardsurface with creasetool - micheus - 12-20-2015 03:31 PM
RE: Tutorial on hardsurface with creasetool - studiof - 12-20-2015, 03:33 PM
RE: Tutorial on hardsurface with creasetool - Marcin Maćkowiak - 12-21-2015, 11:18 AM
RE: Tutorial on hardsurface with creasetool - studiof - 01-08-2016, 09:02 PM
RE: Tutorial on hardsurface with creasetool - EvrGrey - 02-28-2016, 12:17 PM
RE: Tutorial on hardsurface with creasetool - LedaBunny - 12-24-2016, 04:28 PM
RE: Tutorial on hardsurface with creasetool - KrisBee - 01-04-2017, 02:44 AM
RE: Tutorial on hardsurface with creasetool - PansyPuckett - 06-14-2017, 07:58 PM
|
User(s) browsing this thread: 1 Guest(s)