|
Sweep between 2 faces
|
|
01-22-2016, 11:44 AM
(This post was last modified: 01-22-2016 12:08 PM by cyseal.)
Post: #1
|
|||
|
|||
|
Sweep between 2 faces
It is possible to sweep between 2 faces without calculating the angle and extruding?
When I sweep, it happens that the faces are not connected in the end because of a small angle or small amount of extruding. Sweep result with 1 extrude,-10 degrees in z-axis. I would like to align 2 faces. https://dl.dropboxusercontent.com/u/13451287/wcap1.PNG I'm making https://www.youtube.com/watch?v=jBCwM898snU |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Sweep between 2 faces - cyseal - 01-22-2016 11:44 AM
RE: Sweep between 2 faces - micheus - 01-22-2016, 01:42 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 02:11 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 02:27 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 02:46 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 02:55 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 03:43 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 03:52 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 04:55 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 05:09 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 05:19 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 05:52 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 06:11 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 06:29 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 06:30 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 06:35 PM
|
User(s) browsing this thread: 1 Guest(s)