|
Extrusion to a vertice
|
|
10-03-2016, 03:48 PM
Post: #1
|
|||
|
|||
|
Extrusion to a vertice
I started my plane project from a cube, and extruded and shaped as required. Now, I have to end it up in a cone, but I cannot find the way of doing it. Following the basic Tutorials, I cut the cube and mirrored and now when I want to apply any of the ways I know to end in a vertice, the best I got was one vertice for each side of the mirror.
Did I made a mistake by starting with a Cube? Is there any way to converge from the last face to a vertice? Attached is the file with the design so that anyone with more experience can help me, it has the original. Thanks a lot.  Integrated fuse 1.wings (Size: 195.7 KB / Downloads: 2)
|
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Extrusion to a vertice - rcrichfl - 10-03-2016 03:48 PM
RE: Extrusion to a vertice - micheus - 10-03-2016, 05:04 PM
RE: Extrusion to a vertice - rcrichfl - 10-04-2016, 11:15 PM
RE: Extrusion to a vertice - rcrichfl - 10-05-2016, 12:56 AM
|
User(s) browsing this thread: 1 Guest(s)