Wings 3D Development Forum
/
Wings 3D
/
Interface & Usage
/
How To 
/
Unwraping a curved object (how I do)
/
Unwraping a curved object (how I do)
|
Unwraping a curved object (how I do)
|
|
01-19-2017, 09:09 PM
(This post was last modified: 07-15-2017 02:13 PM by micheus.)
Post: #7
|
||||
|
||||
|
RE: Unwraping a curved object (how I do)
Roadkill can help us to find the tension areas (red/blu - green is good) and I used it to localize and apply Tighten on those areas. It's impossible to get full green colors for curved mesh:
 When everything seems to be OK it's time to select all islands (in Body mode) and use Scale->Normalize Sizes followed by Remap UV->Stretch Optimization. 
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Unwraping a curved object (how I do) - micheus - 01-14-2017, 02:50 AM
RE: Unwraping a curved object (my approach) - micheus - 01-15-2017, 12:50 AM
RE: Unwraping a curved object (how I do) - Marcin Maćkowiak - 01-16-2017, 08:07 PM
RE: Unwraping a curved object (how I do) - micheus - 01-17-2017, 04:54 PM
RE: Unwraping a curved object (how I do) - micheus - 01-18-2017, 09:55 PM
RE: Unwraping a curved object (how I do) - micheus - 01-19-2017, 08:32 PM
RE: Unwraping a curved object (how I do) - micheus - 01-19-2017 09:09 PM
RE: Unwraping a curved object (how I do) - Marcin Maćkowiak - 01-19-2017, 11:10 PM
RE: Unwraping a curved object (how I do) - micheus - 01-19-2017, 11:34 PM
|
User(s) browsing this thread: 1 Guest(s)