|
1000 degree bend?
|
|
01-14-2017, 05:32 PM
Post: #5
|
|||
|
|||
|
RE: 1000 degree bend?
Interesting but look at the angle as he does the bend. It's about 12°. in that case it's fairly obvious what's going on. Once it's bent 360° each segment occupies 1/30 of a full circle. In the case of the bend in the middle of a rod it isn't so obvious. But no need to dig any deeper. I was doing it wrong, job sorted, thanks.
Cheers Gordon |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
1000 degree bend? - changrilla - 01-14-2017, 12:14 PM
RE: 1000 degree bend? - micheus - 01-14-2017, 04:11 PM
RE: 1000 degree bend? - changrilla - 01-14-2017, 04:20 PM
RE: 1000 degree bend? - micheus - 01-14-2017, 04:28 PM
RE: 1000 degree bend? - changrilla - 01-14-2017 05:32 PM
|
User(s) browsing this thread: 1 Guest(s)