|
Hardware
|
|
02-10-2017, 02:58 PM
Post: #2
|
|||
|
|||
|
RE: Hardware
It is never a great idea to upgrade hardware to overcome what could be a software technical issue if for any reason the STL exporter should by itself ... be the source of poor performance.
You would really settle for a 50% improvement ? If you can or would trust me to TEST EXPORT your models to see what I think about performance ... I'd at least try to see what's going on. But you might need to keep models confidential. You could always do a deform crumple before you send to me. LOL. It's topology that prob matters here ... not precise geometry. There must be some way someone can do a sanity check for you before you spend $$$. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Hardware - changrilla - 02-10-2017, 02:19 PM
RE: Hardware - ggaliens - 02-10-2017 02:58 PM
RE: Hardware - changrilla - 02-10-2017, 03:14 PM
RE: Hardware - micheus - 02-10-2017, 04:48 PM
RE: Hardware - changrilla - 02-10-2017, 05:03 PM
RE: Hardware - dgud - 02-10-2017, 05:40 PM
RE: Hardware - changrilla - 02-11-2017, 09:04 AM
|
User(s) browsing this thread: 1 Guest(s)