Wings 3D Development Forum / Wings 3D / Interface & Usage v / A trouble in modelling snowman

New Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
Share Thread:
Reddit Facebook Twitter
A trouble in modelling snowman
05-22-2017, 11:11 PM (This post was last modified: 05-26-2017 09:03 PM by Drayldan.)
Post: #1
Drayldan Offline
Junior Member
 		Posts: 5
Joined: May 2017
Shocked A trouble in modelling snowman
Hi, I'm starting to play around with WINGS3D. Smile

I try to model simple figure of a snowman. I wanted to add a hat (from a cylinder),
But the result is undesirable. I cannot get a satisfactory roundabout hat - here from selection faces.
When I do "extrude" option, some unnecessary elements appear.
Besides, I would like to have this roundabout without a crack (holes).
What am I doing wrong, could you advice anything?
Find Reddit Facebook Twitter
Reply
New Reply


Messages In This Thread
A trouble in modelling snowman - Drayldan - 05-22-2017 11:11 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Wings 3D Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication