|
A trouble in modelling snowman
|
|
05-24-2017, 03:21 PM
Post: #2
|
|||
|
|||
|
RE: A trouble in modelling snowman
Hi, welcome to forum.
Maybe your mesh isn't clean? Did you try to use cleanup? Perhaps you did unwanted edges and while extruding it's getting weird. You can always try to start everything again. Start with cylinder, select one edge, use "G" to select edge ring, switch to faces and try to extrude. It should works fine without problems Follow me: YOUTUBE WEBPAGE |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
A trouble in modelling snowman - Drayldan - 05-22-2017, 11:11 PM
RE: A trouble in modelling snowman - Marcin Maćkowiak - 05-24-2017 03:21 PM
RE: A trouble in modelling snowman - Jan Oorthuijsen - 05-24-2017, 05:07 PM
RE: A trouble in modelling snowman - Drayldan - 05-26-2017, 01:31 PM
RE: A trouble in modelling snowman - Drayldan - 05-26-2017, 08:06 PM
RE: A trouble in modelling snowman - Jan Oorthuijsen - 05-27-2017, 04:54 PM
RE: A trouble in modelling snowman - Drayldan - 05-28-2017, 08:44 PM
RE: A trouble in modelling snowman - micheus - 05-28-2017, 10:21 PM
RE: A trouble in modelling snowman - Drayldan - 05-30-2017, 11:16 PM
RE: A trouble in modelling snowman - micheus - 05-31-2017, 05:59 AM
|
User(s) browsing this thread: 1 Guest(s)