Wings 3D Development Forum / Wings 3D / Interface & Usage v / A trouble in modelling snowman

New Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
Share Thread:
Reddit Facebook Twitter
A trouble in modelling snowman
05-28-2017, 08:44 PM (This post was last modified: 05-28-2017 08:57 PM by Drayldan.)
Post: #7
Drayldan Offline
Junior Member
 		Posts: 5
Joined: May 2017
RE: A trouble in modelling snowman
Yes, I did it but it does not help me in this situation.

What's the best combination of options to: use cylinder, select lower half of it, split cylinder and then extrude lower part to get "roundabout" ?

There is a 'slide' option among the commands, but I am not sure it is the right one to split some mesh....
Find Reddit Facebook Twitter
Reply
New Reply


Messages In This Thread
A trouble in modelling snowman - Drayldan - 05-22-2017, 11:11 PM
RE: A trouble in modelling snowman - Drayldan - 05-28-2017 08:44 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Wings 3D Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication