|
Weld Command and UV map
|
|
09-14-2017, 09:13 PM
Post: #11
|
||||
|
||||
|
RE: Weld Command and UV map
Just for share...
(09-13-2017 10:17 PM)micheus Wrote: You probably will not smooth the object, so if you don't mind to have some extra and tiny faces close to the weld region then you could try to extrude a short amount the face that will be welded. But, use the Weld [RMB] and set the tolerance to a shorter value.I tried and it "works". Extrude->Normal by 0 offset and in the Weld->Tolerance it was used 0.000: 
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Weld Command and UV map - gap - 09-13-2017, 06:48 PM
RE: Weld Command and UV map - micheus - 09-13-2017, 08:37 PM
RE: Weld Command and UV map - gap - 09-13-2017, 08:55 PM
RE: Weld Command and UV map - micheus - 09-13-2017, 09:08 PM
RE: Weld Command and UV map - gap - 09-13-2017, 09:56 PM
RE: Weld Command and UV map - micheus - 09-13-2017, 10:17 PM
RE: Weld Command and UV map - gap - 09-13-2017, 11:13 PM
RE: Weld Command and UV map - micheus - 09-14-2017, 01:34 AM
RE: Weld Command and UV map - gap - 09-14-2017, 08:00 AM
RE: Weld Command and UV map - micheus - 09-14-2017, 09:05 AM
RE: Weld Command and UV map - micheus - 09-14-2017 09:13 PM
RE: Weld Command and UV map - micheus - 09-15-2017, 11:14 AM
RE: Weld Command and UV map - gap - 09-21-2017, 12:37 PM
|
User(s) browsing this thread: 1 Guest(s)