|
Suggestion
|
|
06-22-2019, 11:13 AM
Post: #1
|
|||
|
|||
|
Suggestion
Couldn't find where to put this as it isn't a gripe, complaint or anything else I could see.
I use the absolute move command on a frequent basis and wondered if there was a way to "copy/paste" the position of a selected vertice/ face or edge. At the moment, when I wish to use the absolute command I have to select the point I want, select move - absolute, and then copy the axis value I require to move something to. It's a pain in the proverbial neck lol. Just wondering 
My book(s); An Introduction to 3D Modelling with Wings3D Volume I My Twitter |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Suggestion - RubberMan - 06-22-2019 11:13 AM
RE: Suggestion - micheus - 06-22-2019, 12:56 PM
RE: Suggestion - dgud - 11-13-2019, 04:11 PM
|
User(s) browsing this thread: 1 Guest(s)