|
Vertex Vortex ...
|
|
04-15-2013, 12:57 AM
(This post was last modified: 04-15-2013 01:02 AM by ggaliens.)
Post: #3
|
|||
|
|||
|
RE: Vertex Vortex ...
Yeah ... a lot of these are there "Just in case". And "just because". Something like "select by hypotenuse". I mean ... why the heck not ? It is not in plain old wings3D. A fifth grader might articulate the function based on a triangle face selection.
If you can think of it that easily ... it should be available. Gald you like Wegg. Perhaps helpful with a future cup-cake swirl. P.S. Tighten helps to chill down the discontinuity that seems to happen at outside edge of swirl if you swirl too much. Works very well with tighten. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Vertex Vortex ... - ggaliens - 04-14-2013, 10:00 PM
RE: Vertex Vortex ... - Wegg - 04-14-2013, 10:59 PM
RE: Vertex Vortex ... - ggaliens - 04-15-2013 12:57 AM
RE: Vertex Vortex ... - Dimitri - 04-15-2013, 11:54 AM
|
User(s) browsing this thread: 1 Guest(s)