Wings 3D Development Forum
/
Wings 3D
/
Interface & Usage 
/
'Put on' hanging up with just a cancel window
/
'Put on' hanging up with just a cancel window
|
'Put on' hanging up with just a cancel window
|
|
01-15-2020, 04:15 AM
(This post was last modified: 01-15-2020 05:06 AM by digitaldavinci.)
Post: #1
|
|||
|
|||
|
'Put on' hanging up with just a cancel window
I attempt to do a put on. I select one outer face face from cylinder, RMB put on, LMB, select one side of faces on cube, RMB. I get cancel window and nothing happens.
Attached is project. I believe too many faces selected? Wings 2.2.3 |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
'Put on' hanging up with just a cancel window - digitaldavinci - 01-15-2020 04:15 AM
RE: 'Put on' hanging up with just a cancel window - nigec - 01-15-2020, 09:10 AM
RE: 'Put on' hanging up with just a cancel window - micheus - 01-15-2020, 12:37 PM
|
User(s) browsing this thread: 1 Guest(s)