|
How would you make this?
|
|
05-17-2020, 08:45 PM
(This post was last modified: 05-18-2020 08:59 PM by micheus.)
Post: #2
|
|||||||
|
|||||||
|
RE: How would you make this?
Tip from Dropbox support: in order to share images from Dropbox you can replace the termination in the image link ?dl=0 by ?raw=1
Quote:The internal hole for the finger is 18mm in diameter and the stone is 5mm in diameter.Wings3D doesn't works with any specific metric system. We are going to be talking about WU (Wings3D Unit) and you may need to achieve its relationship with the application you will export your model. I've talked about this recently in this post. Quote:Do you think it's achievable?Yes. It will be easily? Maybe not so trivial. But, I'm going try to prepare some steps to reach at least that shape.
|
|||||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How would you make this? - PWD - 05-17-2020, 01:33 PM
RE: How would you make this? - micheus - 05-17-2020 08:45 PM
RE: How would you make this? - PWD - 05-18-2020, 08:00 PM
RE: How would you make this? - micheus - 05-18-2020, 08:58 PM
RE: How would you make this? - PWD - 05-18-2020, 09:17 PM
RE: How would you make this? - micheus - 05-19-2020, 02:01 AM
RE: How would you make this? - PWD - 05-19-2020, 08:04 PM
RE: How would you make this? - oort - 05-19-2020, 11:25 PM
RE: How would you make this? - PWD - 05-23-2020, 12:52 PM
|
User(s) browsing this thread: 1 Guest(s)