Wings 3D Development Forum / Wings 3D / Wings 3D v / Designing for 3D printing (and Wings vs Sketchup Questions)

New Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
Share Thread:
Reddit Facebook Twitter
Designing for 3D printing (and Wings vs Sketchup Questions)
05-12-2013, 04:29 AM
Post: #4
alejandro Offline
Junior Member
 		Posts: 2
Joined: May 2013
RE: Designing for 3D printing (and Wings vs Sketchup Questions)
Thank you both! It think I am sold on Wings 3D enough to give a serious crack at learning it. It seems to be underused over at soliforum.com, so I linked this thread there.
Find Reddit Facebook Twitter
Reply
New Reply


Messages In This Thread
RE: Designing for 3D printing (and Wings vs Sketchup Questions) - alejandro - 05-12-2013 04:29 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Wings 3D Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication