|
Making pipes - some questions
|
|
05-19-2013, 08:49 AM
Post: #4
|
|||
|
|||
RE: Concept chair - W.I.P. with some questions
(05-18-2013 11:23 PM)micheus Wrote: It was hard rotate each edge loop around its own axis in order to twist the curved pipes: Dunno how you did it, m, but I probably would've Selected eloop Edge | rotate > rmb (and selected same eloop for its normal) noted angle if eyeballed select next eloop CntrlD etc etc Only doing the minimum number of ops - then mirror etc. I hope whatever tube it's made from is suitably rated for the calorie challenged individuals in our midst  pp |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Making pipes - some questions - micheus - 05-18-2013, 07:03 PM
RE: Concept chair - W.I.P. with some questions - micheus - 05-18-2013, 08:12 PM
RE: Concept chair - W.I.P. with some questions - micheus - 05-18-2013, 11:23 PM
RE: Concept chair - W.I.P. with some questions - puzzledpaul - 05-19-2013 08:49 AM
RE: Concept chair - W.I.P. with some questions - micheus - 05-19-2013, 10:36 AM
|
User(s) browsing this thread: 1 Guest(s)