Wings 3D Development Forum / Wings 3D / Interface & Usage v / Looking for Fibonacci curve

New Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
Share Thread:
Reddit Facebook Twitter
Looking for Fibonacci curve
06-14-2013, 11:10 PM (This post was last modified: 07-06-2021 05:30 AM by micheus.)
Post: #13
micheus Offline
Forum's Admin and Support
 		Posts: 3,354
Joined: Jun 2012
RE: Looking for Fibonacci curve
This approach seems to give me a better result:

It should be the natural way - without duplicate and reverse the spirals as in first try. Also, in that situation I was not able to weld or even use boolean operation in order to get just one object.

The bridge operation over that thin extrusion produced an interesting result if I apply Smooth Preview:
Website Find Reddit Facebook Twitter
Reply
New Reply


Messages In This Thread
Looking for Fibonacci curve - micheus - 06-09-2013, 05:48 PM
RE: Looking for Fibonacci curve - micheus - 06-14-2013 11:10 PM
RE: Looking for Fibonacci curve - micheus - 08-20-2013, 12:38 AM
RE: Looking for Fibonacci curve - Britfox - 08-20-2013, 06:12 PM
RE: Looking for Fibonacci curve - micheus - 08-20-2013, 08:32 PM
RE: Looking for Fibonacci curve - micheus - 10-23-2013, 09:37 PM
RE: Looking for Fibonacci curve - micheus - 05-23-2014, 09:00 PM
RE: Looking for Fibonacci curve - micheus - 06-08-2014, 12:09 AM
RE: Looking for Fibonacci curve - Nova - 06-08-2014, 09:53 AM
RE: Looking for Fibonacci curve - Arg Arg - 06-08-2014, 10:06 AM
RE: Looking for Fibonacci curve - micheus - 06-08-2014, 11:12 AM
RE: Looking for Fibonacci curve - tkbd - 06-11-2014, 11:26 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Wings 3D Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication