[howto] Cut body depending on other face/axis

[puzzledpaul]

(06-21-2013 12:46 PM)lennart Wrote:  ... but didn't understand the pass-through-point.
...

This is a unique point through which the (already specified) cutting plane will pass.

eg imagine you'd made a table with 4 legs and you wanted to cut the legs in half.

select the table top (face) as the cutting plane

select one of the vertical edges associated with any table leg (wings will assume you want the mid point of that selected edge) as the point thro which the plane will pass.

apply / ok

For any cutting plane you specify, there's an infinite number of planes parallel to it ... the 'point' feature in wings allows you to specify *exactly* where you want the plane to pass thro

pp