How to make a trumpet bell

[gungazoid]

(11-09-2013 10:14 PM)Justanother1 Wrote:  Ok a good way to learn about Tweek. Make a cylinder, standard is fine. Select one of the ends, scale it down. now select one of the edges, hit (G) for the Edge ring, hit a number to subdivide - 8 should be good, then press © to connect them. Now with all that selected, switch to polygon mode, hit (-) to shrink your selection, then point at one of the polygons hit the left button and drag (make sure Tweek is on) (T) ..this should build the base geometry. From there select the bigger end and (polygon) and Intrude ..... should be what your lookin for..

I really appreciate the help, and I'm sorry to be so stupid, but you are speaking at least one level beyond my ability...

When you say select one of the edges - of the top ring? when I do that, nothing happens for "G" or "g". When I select one of the edges on the side of the cylinder, it selects to two edges of that polygon that touch the top and bottom rings...

By "polygon mode" I assume you mean the icon at the top of the workspace where I select faces...

From there I was lost. I feel so stupid...