|
Face Select Problem
|
|
11-12-2013, 06:33 PM
Post: #4
|
|||
|
|||
|
RE: Face Select Problem
I'm running WinXP Pro SP3. Lenova laptop with Intel mobile chip set. Updated all drivers.
I think it's important to note that when I install Wings3D 1.0 the face select function works perfectly. This suggests to me that something in the code changed to create this [broken] behavior. Again, my modeling needs are very simple so, I might just live with version 1.0. As a programmer (embedded devices), I think it's a shame that this happened and, apparently, affected a lot of people. BTW... I installed Wings3D on my "tech" machine that I use for drawing schematics, creating pcbs, etc. I also put it on my newer Dell XPS (64-bit Win7) and the latest version works on that. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Face Select Problem - JonnyMac - 11-12-2013, 12:29 AM
RE: Face Select Problem - JonnyMac - 11-12-2013, 08:23 AM
RE: Face Select Problem - oort - 11-12-2013, 04:22 PM
RE: Face Select Problem - JonnyMac - 11-12-2013 06:33 PM
RE: Face Select Problem - micheus - 11-12-2013, 07:58 PM
RE: Face Select Problem - JonnyMac - 11-14-2013, 05:19 AM
RE: Face Select Problem - micheus - 11-14-2013, 05:45 AM
RE: Face Select Problem - JonnyMac - 11-15-2013, 08:20 PM
RE: Face Select Problem - micheus - 11-16-2013, 11:26 AM
RE: Face Select Problem - JonnyMac - 11-18-2013, 02:15 AM
RE: Face Select Problem - micheus - 11-18-2013, 03:18 PM
RE: Face Select Problem - Avros - 12-09-2013, 11:27 PM
|
User(s) browsing this thread: 1 Guest(s)