Hide and Holes

[Geta-Ve]

Just a general gripe here, but I really wish that the hide and hole options were separate from each other. It is all too easy to apply the hole command instead of the hide command, with very little indication as to which you have done.

A few dozen commands later and it is impossible to get your 'holed' geometry back.

A few options I can think of to prevent this.

1. A confirmation box when applying the Hole command
2. Separate the Hide and Hole commands.
3. Coloured edge borders depending on whether the adjacent faces are hidden or holed. Like when you throw on Hard Edges.
4. An adjustable transparency option for hidden geometry, while also locking it off from the user, ie it can't be selected.