|
Tutorial for a lamp
|
|
01-21-2014, 10:43 AM
(This post was last modified: 01-21-2014 10:43 AM by VladD.)
Post: #6
|
|||
|
|||
RE: Tutorial for a lamp
(01-20-2014 03:14 AM)DC64 Wrote: VladD, how did you create the thickened lines on the lampshade? I've completed the neck, and have yet to make the lampshade and bulb. I selected some edges, used Edge:Extrude/normal with a zero extrude distance. Holding down and draging the left mouse button you can set the width of the new edges. The original selection of edge being still selected after the extrude, just hit "F" to convert into a selection of faces, and finallly a second extrude/by face normals (or "D" to repeat/recall the last command). From left to right, the screenshot shows this simple process.  Nice lighting setup, Justanother1! |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tutorial for a lamp - DC64 - 01-19-2014, 12:07 AM
RE: Tutorial for a lamp - VladD - 01-19-2014, 04:21 AM
RE: Tutorial for a lamp - micheus - 01-19-2014, 05:18 AM
RE: Tutorial for a lamp - DC64 - 01-20-2014, 03:14 AM
RE: Tutorial for a lamp - VladD - 01-21-2014 10:43 AM
RE: Tutorial for a lamp - Justanother1 - 01-20-2014, 04:20 AM
|
User(s) browsing this thread: 1 Guest(s)