Right. Next question.
I have a torus where I have performed "voronoi encrust surface".
I can not use polyhedra as cutter as it just leaves a little UFO looking disc in the middle. I used polyhedra as cutter to make the voronoi cube you worked on.
It won't let me use boolean as the tidbits are not exploded outwards.
See screenshot, this is where I'm at....lots of Tidbits coming out of the torus.
Again, I want to "intersect" these shapes with the torus leaving only the edges on the torus's surface. No internal geometry, just a torus with edges.
Wings file:
https://app.box.com/s/ot54dikjtkvtfq1igpt3
This is almost what I'm trying to achieve. I just need the torus without all the gaps in it, only the edges are required. The torus has gaps between the cells because this was the only way I could intersect the Tidbits with the torus, by exploding, combining and then boolean. Any ideas?
I have a torus where I have performed "voronoi encrust surface".
I can not use polyhedra as cutter as it just leaves a little UFO looking disc in the middle. I used polyhedra as cutter to make the voronoi cube you worked on.
It won't let me use boolean as the tidbits are not exploded outwards.
See screenshot, this is where I'm at....lots of Tidbits coming out of the torus.
Again, I want to "intersect" these shapes with the torus leaving only the edges on the torus's surface. No internal geometry, just a torus with edges.
Wings file:
https://app.box.com/s/ot54dikjtkvtfq1igpt3
This is almost what I'm trying to achieve. I just need the torus without all the gaps in it, only the edges are required. The torus has gaps between the cells because this was the only way I could intersect the Tidbits with the torus, by exploding, combining and then boolean. Any ideas?