|
Measurements - Need some help
|
|
12-06-2012, 10:44 PM
(This post was last modified: 12-06-2012 10:44 PM by Fonte Boa.)
Post: #31
|
|||
|
|||
|
RE: Measurements - Need some help
Until the following point i came (cant record video using mrs Fonte Boa notebook):
 Therefore if i use Shift|Planar on the 2 selected faces at pic (one is visible in red, the other is paralel to this first one), picking any vertical edge as Axis and cilinder circular face as center, the transversal piece top and botton faces slide in direction of cilinder... __________________________________ http://www.youtube.com/wings3dchannel http://www.facebook.com/wings3dchannel |
|||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)