Wings 3D Development Forum
/
Wings 3D
/
Interface & Usage 
/
Creating a hole in a cylinder off center
/
Creating a hole in a cylinder off center
|
Creating a hole in a cylinder off center
|
|
12-12-2014, 09:15 AM
Post: #20
|
|||
|
|||
|
RE: Creating a hole in a cylinder off center
Another option would be to utilize the Circularize command. Basically create a rough shaped hole anywhere in your mesh (via bridge of course) and then select the outer loops and use circularize.
Unless I have misunderstood the issue... 
|
|||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)