|
Issue with the Connect Line Tool
|
|
01-07-2015, 11:29 AM
(This post was last modified: 01-07-2015 11:30 AM by Corey.)
Post: #31
|
|||
|
|||
|
RE: Issue with the Connect Line Tool
Apologies for such a late reply, but here are the steps that I took to receive the strange extrusion (I honestly have no idea what I'm doing). What steps would I have to apply to reach well, the appropriate stage. What steps must I take to use the inset tool as a replacement for the contour?
On a side note, what I did might make a good spiral staircase of some sort.. https://www.dropbox.com/s/fkvnslwim0vj7n...T.gif?dl=0 Oh and thanks for still helping out! |
|||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)