|
Bend Tool selection names is confusing
|
|
12-19-2012, 02:25 AM
(This post was last modified: 12-19-2012 02:37 AM by oort.)
Post: #4
|
|||
|
|||
|
RE: Bend Tool selection names is confusing
I think that Bend Clamped is confusing in its prompts as well. When bending metal the clamped part is the part that does not bend. So maybe...
"Top Clamp Point" should be "Bend Start" "Bottom Clamp Point" should be "Bend End" To keep Bend (3 step) different maybe... "Rod Center" should be "Control Point" "Rod Top" should be "Bend Range" or "Bend Distance" "Bend Normal" should be "Bend Direction" Fonte Boa, The videos you posted on Bend are very informative and should help new users of the bend tool. oort |
|||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)