|
Bend Tool selection names is confusing
|
|
12-19-2012, 03:15 PM
Post: #9
|
|||
|
|||
|
RE: Bend Tool selection names is confusing
Fonte Boa,
The image you posted in the tutorial section is very good for discussion here.  Since "Rod Center" is a point that does not move, it makes sense to me to call that a "Control Point". Maybe "Rod Top" should be "Pressure Point", since that is the point at which you push or pull the rod??? oort |
|||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)