|
Bend Tool selection names is confusing
|
|
12-20-2012, 11:58 PM
Post: #25
|
|||
|
|||
|
RE: Bend Tool selection names is confusing
I just tested with Bend Clamped on a cylinder and using verts and I am still seeing the same behavior. As long as you bend the rod in the middle you do not have the problem.
I agree that the naming you suggested is ok even with this behavior. I was just wondering if this behavior could be prevented...  oort |
|||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)