|
hard edges connected = soft edge
|
|
12-20-2012, 06:47 PM
(This post was last modified: 12-20-2012 06:49 PM by Fonte Boa.)
Post: #4
|
|||
|
|||
|
RE: hard eges connected = soft edge
Maker, try to use the command
Body|AutoSmooth. It "automatically" turns some Edges hard, keeping the other ones soft, all this based in a Crease Angle you can set (to this, right click on this command or click on that rectangle side the command name). I found two very old tutorials i've recorded about this: __________________________________ http://www.youtube.com/wings3dchannel http://www.facebook.com/wings3dchannel |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
hard edges connected = soft edge - maker - 12-20-2012, 06:14 PM
RE: hard eges connected = soft edge - Fonte Boa - 12-20-2012, 06:37 PM
RE: hard eges connected = soft edge - maker - 12-20-2012, 06:43 PM
RE: hard eges connected = soft edge - Fonte Boa - 12-20-2012 06:47 PM
RE: hard eges connected = soft edge - maker - 12-20-2012, 07:12 PM
RE: hard eges connected = soft edge - Fonte Boa - 12-20-2012, 08:02 PM
|
User(s) browsing this thread: 1 Guest(s)