|
What are steps to select "HOLE EDGES" ?
|
|
06-05-2015, 02:00 PM
(This post was last modified: 06-05-2015 02:02 PM by ggaliens.)
Post: #7
|
|||
|
|||
|
RE: What are steps to select "HOLE EDGES" ?
I have technical reasons for my problem domain, where I need to keep the hole OPEN.
I tried selecting what seems like all visible vertices ... then hit MINUS to make my selection shrink away from hole. But that does not work. So I'm trying to do it more direct. And I did. I had to make a new command, because it is not in there already. So I think the anwer to my original question is that it's not easy to select hole-edges with current wings. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
What are steps to select "HOLE EDGES" ? - ggaliens - 06-04-2015, 06:01 PM
RE: What are steps to select "HOLE EDGES" ? - micheus - 06-04-2015, 07:24 PM
RE: What are steps to select "HOLE EDGES" ? - ggaliens - 06-04-2015, 10:33 PM
RE: What are steps to select "HOLE EDGES" ? - micheus - 06-05-2015, 01:29 PM
RE: What are steps to select "HOLE EDGES" ? - ggaliens - 06-05-2015, 01:49 PM
RE: What are steps to select "HOLE EDGES" ? - micheus - 06-05-2015, 01:52 PM
RE: What are steps to select "HOLE EDGES" ? - ggaliens - 06-05-2015 02:00 PM
RE: What are steps to select "HOLE EDGES" ? - micheus - 06-05-2015, 02:04 PM
RE: What are steps to select "HOLE EDGES" ? - ggaliens - 06-05-2015, 04:33 PM
RE: What are steps to select "HOLE EDGES" ? - micheus - 06-05-2015, 06:49 PM
RE: What are steps to select "HOLE EDGES" ? - ggaliens - 06-08-2015, 08:58 PM
|
User(s) browsing this thread: 1 Guest(s)